1. The uncleaned air filter element will cause the increase of friction resistance, the restriction of total gas flow and the reduction of pumping efficiency, which will lead to the insufficient output power of the engine of Deutz diesel engine accessories. Clean the diesel engine air filter element or remove the dust on the paper filter element according to the necessity, and carry out the replacement when necessary.
2. The oil advance angle provided by Deutz diesel engine parts is too large or too small. If the fuel supply advance angle is large or too small, the fuel injection time of the fuel pump will be too early or too late. At this time, check whether the screw of the oil pump rotating shaft power adapter is loose. If it is loose, adjust the provided oil advance angle again and tighten the screw.
3. Strain force of piston rod and cylinder barrel The strain force of piston rod and cylinder barrel is too large or damaged, and the friction damage of engine piston is increased, which causes the damage of mechanical equipment of the engine itself to increase, the compression ratio of the engine is reduced, and the ignition is difficult or insufficient. Low inflation increases, and the refrigeration and air intake systems have common faults. Too hot parts of Deutz diesel engine are caused by abnormal cooling or humidification system. In this case, the temperature and temperature will be too high, and it may cause cylinder driving or engine piston jamming. When the temperature of the exhaust pipe of Deutz diesel engine accessories increases, check the cooling tower and heat pipe radiator to remove the scale.
4. Deutz Overhaul Company told you that the gas leakage at the connecting surface between the cylinder head and the engine behavior body will cause the gas in the cylinder body to enter the water safety channel or the oil safety channel, and then cause the refrigerant to enter the engine behavior body. Because of the destruction of the cylinder head seal ring, during the whole process of gear shifting, cyclones will spray out of the cylinder head seal ring, and bubbles will occur on the seal ring when the engine is running. At this time, tighten it to the required torque.
